SS-2007+ Low Viscosity Gap Filler Thermally Conductive Silicone Rubber
Product Description
SS-2007+ is a low viscosity, room temperature curing, self-leveling high performance thermally conductive liquid silicone gap filling material. A dispensing gun is required for the dual syringes on this thermally conductive gap filler.
Product features
- Silicone gap filler with no odor or byproducts
- Convenient 1:1 mix ratio
- High 2.0 W/m-K thermal conductivity
- Cures at Room Temperature
Typical Applications
- Electronic component thermal dissipation
- Coupling electronic components
- Form in place heat sink
- UNCURED
- Specific Gravity: 2.8
- Uncured Color: Part A - White, Part B - Pink
- Solids: 100.00%
- Shelf Life: Sealed containers are guaranteed for 1 year from the ship date when stored in a cool dry area, below 70°F
- Viscosity: 14,000 cps.
- CURED - R.T.
- Cured: 3-5 Hours at Room Temperature
- Cured Color: Part A - White, Part B - Pink
- Durometer, Shore: 00 70
- Dielectric Strength: 500 V/mil
- Dielectric Constant: 7
- Volume Resistivity: 12
- Thermal Conductivity: 2
Platinum catalyzed thermal compound
Avoid contact with tin cured RTVs, sulphur compounds, azides, imides, latex rubber gloves, and amines as cure system can be deactivated.
Sealed containers are guaranteed for 1 year from the ship date when stored in a cool dry area, below 70°F
All recommendations, statements and technical data herein are based on tests we believe to be reliable and correct, but accuracy and completeness of said tests are not guaranteed and are not to be construed as warranty, either expressed or applied. User shall rely on his own information and tests to determine suitability of the product for the intended use, and the user assumes all risk and liability resulting from the use of this product. Manufacturerメs sole responsibility shall be to replace that portion of product of the manufacturer proves to be defective. Manufacturer shall not be liable to the buyer or any third party for injury, loss or damage directly or indirectly resulting from the use of, or inability to use, the product. Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding by the manufacturer.