SS-8113 2 Part Pourable Silicone Rubber For Potting And Encapsulation - Per Pound
$32.15
Product Description
SS-8113 is a fast curing, pourable silicone RTV rubber developed for potting and encapsulation applications. SS-8113 is a 2-part, variable mix ratio silicone potting, that when mixed, allows handling of the assembly within 45 to 120 minutes. A pound consists of a 16 oz container of base, and a 2 oz container of catalyst.
Product features
- Fast deep section RT cure
- Self-leveling
- Neutral cure silicone potting compound
- Convenient user defined variable mix ratio 100:3-5
Typical Applications
- Electronic component encapsulation
- Electrical potting
- Thermal insulation
- Vibration and moisture insulation
- UNCURED
- Specific Gravity: 1.3
- Uncured Color: Light Blue
- Solids: 98.00%
- Shelf Life: Sealed containers are guaranteed for 6 months from the ship date when stored in a cool dry area, below 70°F
- Viscosity: 3,600 cps.
- Tack Free Time: 45-60 Minutes at Room Temperature
- CURED - R.T.
- Cured: 24 Hours @ Room Temperature
- Durometer, Shore: A 50
- Dielectric Strength: 19.5 kv/mm
- Dielectric Constant: 3.8
- Dissipation Factor: 0.006
- Volume Resistivity: 14
- Thermal Conductivity: 0.17
- Coefficient of Thermal Expansion: -5
Cure speed can be accelerated with increased humidity to very rapid cures, exhibiting surprisingly fast adhesion.
Keep out of the reach of children. Uncured sealant can irritate eyes and skin.
Sealed containers are guaranteed for 6 months from the ship date when stored in a cool dry area, below 70°F
All recommendations, statements and technical data herein are based on tests we believe to be reliable and correct, but accuracy and completeness of said tests are not guaranteed and are not to be construed as warranty, either expressed or applied. User shall rely on his own information and tests to determine suitability of the product for the intended use, and the user assumes all risk and liability resulting from the use of this product. Manufacturerメs sole responsibility shall be to replace that portion of product of the manufacturer proves to be defective. Manufacturer shall not be liable to the buyer or any third party for injury, loss or damage directly or indirectly resulting from the use of, or inability to use, the product. Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding by the manufacturer.